A: When the meter is powered off, short press the"📃"button to view historical data.
Press the "📃" button once to view the memory values of the last three measurements. Press the memory button again to view the "📃" value of the last measurement.
*The blood pressure monitor can store up to 2 groups of 99 historical data for each user.

A: When the device is turned off, short press the "SET" button twice to enter the user icon, and press the "📃" button to switch between "1", "2"users. Press the "Power" button to turn off and save.

A: Press the "SET" button eight times, the high voltage area displays "SP", and the speaker switch setting state is entered.
Press the "📃" button to adjust the speaker switch (ON, OFF), and the speaker switch setting is completed. Press the"START/STOP" button to shut down and save.

A: When the device is turned off, short press the "SET" button once. If the unit is mmHg, press the "📃" button to switch to kPa. The screen displays0.0kPa, indicating that the setting is successful.
Press the "START/STOP" button to turn off and save.

A: In the off state, short press the "SET" button three times to enter the date adjustment, press the memory key to adjust the year, and then press the "SET"button, the month flashes, and enter the month setting state.
Press the "📃" button to adjust the month, and then press the "SET" button, the date flashes, and enter the date setting state.
Press the "📃" button to adjust the date, and then press the "SET" button, the hour flashes, and enter the hour adjustment state.
Press the "📃" button to adjust the hour, and then press the "SET" button, the minute flashes, and enter the minute setting state.
Press the "📃" button to adjust the minute, and the minute setting is completed. Press the "START/STOP" button to shut down and save.
Please note that the new settings will not be saved after power failure.

In the off state, short press the "SET" button nine times, and "CL" is displayed. Press the "📃" button and the "START/STOP" button at the same
for about 2 seconds.
When the screen displays all "--", the memory is deleted. Memory deletion deletes all measurement data under all users at one time.

1. Avoid caffeinated beverages, smoking, or alcohol before measuring your blood pressure.
2. Measure your blood pressure at a fixed time. Because blood pressure rises slowly within two hours after waking and slowly falls before bedtime, blood pressure may vary significantly at different times. Therefore, it is important to measure your blood pressure at a fixed time to ensure consistent readings. Also, be sure to measure your blood pressure before taking antihypertensive medications.
3. Wear appropriate clothing. If you are wearing light clothing, you can measure your blood pressure directly; if you are wearing thick clothing or a jacket, you must remove them before measuring.
4. Before measuring, relax and allow your heart rate to calm, resting for at least 5 minutes.
5. Ensure that the blood pressure cuff is properly attached to the blood pressure monitor.Wrap the cuff around the upper arm(usually the left upper arm)and place the airway tube on the forearm. The bottom of the cuff should be 2cm-3cm above the inner side of the elbow joint of the upper arm. Wrap the cuff tightly and secure it with a cloth buckle. Leave a finger gap between the arm and the cuff.
6. Sit upright with your feet flat on the floor. Extend your arm to be measured, palm facing up. Keep the cuff at the same level as your heart.
7. Stay focused and avoid talking during the measurement.
Tips: Try to use the same arm each time to ensure consistent readings.
The human body's blood pressure is constantly changing and is affected by many factors, so the values measured multiple times may fluctuate.